SYSTEM DRAWINGS

NOTE: Photos are of prototypes only and are not an exact representative of the finished product.

CLIMATE-DECK™ can use ALUMINUM ROLL BUCKS attached to the shoring equipment to temporarily brace the foam during forming and pouring. 

NOTE: Photos are of prototypes only and are not an exact representative of the finished product.

CLIMATE-DECK™ use ONLY 4 PLASTIC PARTS to create several different connections within the Floor/Roof and Ceiling systems.

1 = EXTERIOR REBAR CHAIR

2 = INTERIOR REBAR CAGE/CONNECTOR

3 = VERTICAL CEILING TIE

4 = LOCKING WEDGE PIN

NOTE: Photos are of prototypes only and are not an exact representative of the finished product.

CLIMATE-DECK™ INTERIOR REBAR CAGE/CONNECTORS are engineered plastic rebar placement gigs that hold the structural rebar in the exact spacing and a 2" clearance from the concrete edge as designed by the structural engineer.   

NOTE: Photos are of prototypes only and are not an exact representative of the finished product.

CLIMATE-TIES™ VERTICAL CEILING TIES are designed to mechanically fasten the ceiling furring members below to the structural concrete beams above.

NOTE: Photos are of prototypes only and are not an exact representative of the finished product.

CLIMATE-TIES™ Walls Systems are made from injection molded PLASTIC POLYMERS.

CLIMATE-TIES™ Wall Systems are currently designed to work with two of the main concrete foundation forming systems on the market, Aluminum & Steel Concrete Panel Forms.

CLIMATE-TIES™ Wall Systems have ONLY 4 PLASTIC COMPONENTS.

1 = CENTER TIE or Interior Center of Wall Tie

2 = CENTER TIE w/POSTS: or Interior Center of Wall w/90º Corner Tie Connection Posts

3 = T-TIE or Exterior of Wall T-Tie

4 = 90º CORNER TIE or  Exterior Corner Tie

NOTE: Photos are of prototypes only and are not an exact representative of the finished product.

CENTER TIE: This tie is placed in the concrete wall by way of inserting a de-burred & tempered metal concrete form tie through the center of the plastic center tie and placing it to the concrete forms securing it between the interior and exterior concrete panels. 

Once the concrete has been poured and the forms are stripped from the concrete wall, the de-burred & tempered metal concrete form ties will be removed, leaving an opening for the T-Tie to enter and mechanically lock itself to the concrete wall. 

This is accomplished with our PATEN PENDING DESIGN that uses Zip-Tie type technology to MECHANICALLY LOCK them together.

NOTE: Photos are of prototypes only and are not an exact representative of the finished product.

T-TIE: This tie is inserted into the CENTER TIE that is ready to have furring strips such as metal or wood mechanically fastened to them creating a surface to attach exterior cladding to.

NOTE: Photos are of prototypes only and are not an exact representative of the finished product.

90º CORNER TIE: This tie is attached by locking itself to a CENTER TIE w/POSTS The center tie has custom attachment posts. 

The out most exterior edges of this tie are designed to insert the CENTER TIE w/POSTS to one of the two sides, creating an attachment point for the T-TIE that will be flush with the exterior edge of the concrete wall. 

This will allow the framing contractor to create a 90º/CALIFORNIA CORNER to attach the furring strips to.